Again and again the water drains out of the flowerpot too slowly. Preferably make holes in the plastic flower pots to solve the problem.

Why holes in the flower pot?

Holes in the flower pot are important because they ensure adequate water drainage. When watering the plants, it is impossible to estimate the needs of the same. The water thus remains in the soil and the plants draw moisture out as needed. However, a sopping wet soil is counterproductive. Consequently, small openings in the flowerpot should allow excess water to drain away. If the small holes are not sufficient from the production, you can help.

materials and tools

Depending on the procedure, you need different materials and tools to make holes in plastic flower pots. You can’t go wrong with the following things and you can follow every guide:

  • plastic flower pots
  • candle
  • screwdriver
  • Messer
  • Nagel
  • drilling machine

Making holes in flower pots: instructions

Step by step you can make holes in your plastic flower pots. The following section provides instructions for these procedures:

  • candle
  • Messer
  • screwdriver
  • drilling machine
Note: Many flower lovers rely on hammer and nails. However, the risk is significantly higher, so the following procedures are more recommended for making holes in plastic flower pots.

Variant 1: candle

Making a hole with a candle is easy and safe. Light it and hold it under the plastic. After a few seconds, the plastic will soften in the respective area. You can now pierce the flower pot with a screwdriver or nail.

Variant 2: knife

For this variant, use a serrated knife. Place the knife where you want it and carefully cut off a piece of plastic. You can then pierce the flower pot.

Variant 3: Screwdriver

Perforating the flower pots with a screwdriver is only suitable for certain specimens. If the plastic is stable, you can slowly apply the screwdriver. With cheap variants, cracks are the order of the day.

Variant 4: drill

You can also use a metal drill to drill a hole in sturdy pots. To do this, place the pot upside down. Now carefully drill holes in the pot. Be careful not to place the pot on the lawn as plastic shavings will fly around.

Note: Be sure to turn off the hammer drill function. Otherwise, there will most likely be cracks or breaks instead of clean holes in the plastic of the plastic flower pots.

frequently asked Questions

If the water cannot drain out of the flower pot, waterlogging forms . The roots are continuously in moist soil. The plant cannot absorb oxygen and only insufficient nutrients.

If you want to prevent waterlogging, you should check plants and flower pots regularly. Coasters and planters partially prevent the water from draining off. Make sure that the holes in the flower pot do not become clogged with soil.

When waterlogged, the leaves of the plant often turn yellow. Then you should check the soil in the pot directly and, if necessary, make new openings for the water drainage.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *